• Kürşat Albayraktaroğlu (now a design engineer at Intel, Austin TX) “Design and implementation of a PCI bus interface for atomic-force-microscope”
  • Engin Avcı “Design of a four-layer PCB board of a communication system” (Jan 2000)
  • Engin Avcı and İlhan Kaya “Design of a low-noise microwave amplifier” (June 2000)
  • Elif Aydoğdu (ASELSAN) “Design and simulation of MEMS variable capacitor based mechanical to electrical energy converter unit” (Jun 2004)
  • Mehmet Emin Başbuğ (Researcher at Lion Cave Capital) “Design and implementation of a laser Doppler vibrometer to measure vibrations of CMUTs”
  • Barış Bayram (Assoc Prof at METU) “Turns-ratio and figure of merit comparison of mushroom-shaped and drum-shaped CMUTs” (May 2000)
  • Barış Bayram “Harmonic analysis of mushroom-shaped and drum-shaped CMUTs under stress” (Dec 1999)
  • Can Bayram (Assist Prof at Univ of Illinois at Urbana-Champaign) “Gain-bandwidth product and bandwidth improvement in CMUT array with mixed size cells” (May 2005)
  • Said Boybay (Assist Prof at Antalya International Univ) and Emre Togan (ETH Zurich) “Focusing of acoustic waves in planar layered media” (Jan 2004)
  • Said Boybay and Emre Togan “Designing and efficient lens for focusing acoustic waves in planar media” (Jun 2004)
  • Volkan Cevher (Prof at EPFL) “Design and simulation of an operational amplifier; Building block for a photodetector array and an instrumentation amplifier”
  • Abdullah Çelik (Product Line Director, Analog Devices) “Cross-coupling in CMUT arrays”
  • Abdullah Çelik “Finite-element modeling of cross-coupling in CMUTs”
  • İlker Deligöz “Theory and analysis of electrode-size optimization for CMUTs” (Jan 2002)
  • İlker Deligöz “Comparison of finite-element and numerical solutions of CMUTS” (Jun 2002)
  • Kaya Demir “Electrical circuit modeling of atomic-force-microscope tip-sample interactions”
  • Ali Özer Ercan (Assist Prof at Özyeğin Univ) “Improvement of a CMOS OPAMP”
  • Tamer Güdü “Design of a high-voltage multichannel operational amplifier”
  • Gökçe Keskin “MEMS detection in MRI” (May 2003)
  • Cihan Kıykaç (Bus. Dev. Director at Citus Power) “Design of a (31,23) Reed-Solomon encoder for error-correction coding”
  • Çağla Kıvılcım Koru “Design of a flyback-converter” (Jun 2005)
  • Alper Kiraz (Prof at Koç Univ) and Alaeddin Aydıner “Design, simulation and implementation of an instrumentation amplifier” (Dec 1997)
  • Hakan Köklü “Improvements in the performance of CMUT by using non-uniform membrane structures”
  • Selçuk Köse and Burak Şekerlisoy “Implementation of an adaptive digital predistortion for linearization of RF amplifiers”
  • Kıvanç Mıhçak (Quantitative trader at Jump Trading, Chicago) and Mücahit Kozak (Senior manager at Synaptics, Austin TX) “VHDL coding of DTMF receiver simulation and optimization using Synopsys” (Jan 1996)
  • Erdinç Mutlu “Design and implementation of the PCI bus interface of the atomic-force-microscope”
  • Sedat Nizamoğlu (Assist Prof at Koç Univ) “Adaptive digital predistortion techniques for linearization of RF amplifiers”
  • Selim Olçum (Co-founder and Director of Engineering at Travera) “Comparison of mushroom and drum shaped CMUTs”
  • Mehmet Önsiper and Soner Başaran (R&D manager at Polen Seed Company) “Application specific processor of LDPC decoder”
  • Erhan Özalevli (IC design engineer at Texas Instruments) “A ROM based correlator design and test software for a radiolink”
  • Mustafa Özdal (Assist Prof at Bilkent)  “Software for atomic-force-microscope”
  • Bülent Özel (Data Science Consultant, Researcher and Lecturer, Universitat Jaume I) “PCI bus interface for atomic-force-microscope”
  • Mehmet Özgür (Engineer at MNX, Virginia) “Design and implementation of 10MHz to 2GHz medium-power RF amplifier”
  • Zehra Parlak (Founder and Acting CEO at QATCH Technologies) and Duygu Kuzum (Assist Prof at UCSD) “Non-destructive method for subsurface defect size detection”
  • Fatih Sarıoğlu (Assist Prof at Georgia Tech) “Non-destructive detection of subsurface cracks and disbonds using AFM” (Jan 2003)
  • Zekeriya Şahin (Program manager at ASELSAN) “Designing a pacemaker involving fiber-optic communication channel between generator and cardiac” (May 2005)
  • Muhammed Şenlik (Senior expert engineer at ASELSAN) “Amplifier linearization techniques” (Jul 2001)
  • Şennur Ulukuş (Prof at Univ of Maryland) “A rootfinder program written in C programming language” (Jan 1991)
  • Can Uran (Senior optical systems design engineer at Vestel Electronics) “Area efficient 5-bit DAC”
  • Mustafa Yazgan (Software engineer at Google) “Writing a graphics program for viewing 3D inputs: GrView”
  • Mustafa Yazgan “Writing a graphics interface for PLAWE and SPICE simulator outputs”
  • Hüseyin Yavuz (ASELSAN) “Design of an EPROM programmer” (Jul 1985)
  • Özlem Yılmaz (ASELSAN) and Makbule Pehlivan (Engineer at STM) “Variable MEMS capacitor design for mechanical energy to electrical energy converters” (May 2005)